3rd Annual DDM Novastar Open House a Success


Reading time ( words)

For the third consecutive year, DDM Novastar held its annual Technical Workshop and Open House on September 15-17, 2015 and was, by all measure, an enormous success.

The Technical Workshop was attended by customers from Canada, Connecticut, New Jersey, New York, South Carolina, Virginia and as far away as Florida. Because the workshops have proven so worthwhile to customers, DDM Novastar has already scheduled their mid-winter workshop for February 9-10, 2016.

Participants were able see all of DDM Novastar's products first-hand in a single location, ask technical questions, meet the team that supports the equipment, and take a tour of the company's exclusive U.S. manufacturing and assembly facility.

The Open House featured hands-on equipment demonstrations including screen printers, pick & place machines, reflow ovens and selective solder machines, a custom reel-to-reel assembly line, and feeders, controls, and ancillary components.

About DDM Novastar

DDM Novastar, Inc, was established in 2011, following the close of APS Novastar, LLC, formerly of Huntingdon Valley, PA. Many of the key staff from APS were hired by DDM Novastar to continue the legacy started by APS in 1981. DDM Novastar continues in their footsteps as the global leader in the design, development, and manufacture of OEM equipment for the short to medium run surface mount technology (SMT) and printed circuit board (PCB) markets.

DDM Novastar's products include stencil printers, automated pick and place robots, reflow ovens, wave and selective solder equipment, component counters and lead forming equipment. DDM Novastar's experienced team has installed over 24,000 product solutions in the telecom, defense and aerospace, security, transportation, automotive, medical and diagnostic devices, personal computers, and academic markets. For more information, visit www.ddmnovastar.com.

Share

Print


Suggested Items

SMTA Europe Webinar: What Is a Good Solder Joint, and How Can Solder Joints Be Tested?

11/18/2020 | Pete Starkey, I-Connect007
What is a good solder joint? And how can they be tested not only for purposes of process characterisation, optimisation, monitoring, and control but also for ensuring their long-term reliability? Pete Starkey details a webinar organised by the Europe Chapter of SMTA that was presented by Bob Willis, an expert in soldering, assembly technologies, and failure analysis.

This Month in SMT007 Magazine: Test and Measurement in a Smart Factory

11/03/2020 | Nolan Johnson, I-Connect007
Nolan Johnson spoke with MIRTEC President Brian D’Amico about how the role of test and measurement equipment is changing in the smart factory and how shops can adjust to make use of the new technology. D’Amico shares this insight: “While approximately 90% of U.S. electronics manufacturers recognize the potential of Industry 4.0 to improve productivity, many are slow to adopt smart factory solutions within the manufacturing process.”

Reducing Flux Splatter in Sensors and Camera Modules

10/30/2020 | Jasbir Bath, Shantanu Joshi, and Noriyoshi Uchida, Koki Solder America And Koki Company Limited
With the increased use of electronics in new technology areas, flux formulations are being developed to address the new and existing requirements. For sensors and camera modules used for Advanced Driver Assistance System (ADAS) and internet of things (IoT) applications, there is a demand for no-clean flux formulations in lead-free solder paste, which can reduce flux splattering during reflow.



Copyright © 2020 I-Connect007. All rights reserved.