NASA, Industry Complete Third Phase of UAS Flight Testing
September 17, 2015 | NASAEstimated reading time: 2 minutes
Evolving technologies necessary for Unmanned Aircraft Systems (UAS) to safely avoid other aircraft while moving through the nation's skies recently were put to the test using NASA's remotely piloted Ikhana aircraft.
Equipped with a prototype system of Detect-and-Avoid (DAA) sensors working in concert with airborne and ground-based computers, Ikhana made 11 flights involving more than 200 scripted encounters with approaching aircraft.
Depending on the specific scenario, either Ikhana detected one or more approaching aircraft and sent an alert to its remote pilot to take action, or Ikhana itself took action on its own by flying a programmed maneuver to avoid a collision – an aviation first.
"We recorded some valuable data that will take some time to analyze fully, and we expect we'll need to make some minor refinements to our algorithms, but from what we saw during the tests, the results look promising," said Dennis Hines, NASA's director for programs for Armstrong Flight Research Center at Edwards, CA.
Staged from Armstrong and flown over the high desert of California, the DAA research was designated FT3, the third in a series of flight test campaigns for NASA’s Unmanned Aircraft Systems Integration in the National Airspace System (UAS-NAS) project.
“The successful completion of this flight test campaign represents the maturity of our detect-and-avoid system,” said Frank Pace, president of Aircraft Systems for General Atomics Aeronautical Systems, Inc.
As a NASA industry partner, the company developed one of the three primary DAA sensors flown on Ikhana, in this case a prototype radar system. It also contributed Ikhana system and self-separation and collision avoidance alerting logic software.
The other two sensors included an Automatic Dependent Surveillance – Broadcast (ADS-B) from BAE Systems, and a second generation Traffic alert and Collision Avoidance System (TCAS) from Honeywell International, Inc.
ADS-B is a satellite-based navigation tool in which an aircraft determines its position and then broadcasts that information, enabling other nearby airplanes equipped with the same tool to know where everyone is at in the sky.
As its name implies, TCAS keeps an electronic eye on the sky immediately surrounding an airplane. Should another airplane with a similar device fly too close, an alert will prompt the pilot to take action.
Honeywell also provided software that enabled the three sensors to work together, as well as a specially instrumented aircraft to play the role of an intruder encroaching on Ikhana's airspace.
"This phase of flight tests, and our ability to meet the challenge of integrating UAS into the NAS, wouldn't be possible without the strong partnership that exists between NASA and its aeronautical industry partners," Hines said.
Knowledge gleaned from the data recorded during this third phase of UAS-NAS flight tests not only will help researchers plan the next phase of flight tests – now targeted for next spring – but also will help inform organizations developing UAS-related operating standards.
Suggested Items
Cadence, TSMC Collaborate on Wide-Ranging Innovations to Transform System and Semiconductor Design
04/25/2024 | Cadence Design SystemsCadence Design Systems, Inc. and TSMC have extended their longstanding collaboration by announcing a broad range of innovative technology advancements to accelerate design, including developments ranging from 3D-IC and advanced process nodes to design IP and photonics.
Siemens’ Breakthrough Veloce CS Transforms Emulation and Prototyping with Three Novel Products
04/24/2024 | Siemens Digital Industries SoftwareSiemens Digital Industries Software launched the Veloce™ CS hardware-assisted verification and validation system. In a first for the EDA (Electronic Design Automation) industry, Veloce CS incorporates hardware emulation, enterprise prototyping and software prototyping and is built on two highly advanced integrated circuits (ICs) – Siemens’ new, purpose-built Crystal accelerator chip for emulation and the AMD Versal™ Premium VP1902 FPGA adaptive SoC (System-on-a-chip) for enterprise and software prototyping.
Taiyo Circuit Automation Installs New DP3500 into Fuba Printed Circuits, Tunisia
04/25/2024 | Taiyo Circuit AutomationTaiyo Circuit Automation is proud to be partnered with Fuba Printed Circuits, Tunisia part of the OneTech Group of companies, a leading printed circuit board manufacturer based out of Bizerte, Tunisia, on their first installation of Taiyo Circuit Automation DP3500 coater.
Vicor Power Orders Hentec Industries/RPS Automation Pulsar Solderability Testing System
04/24/2024 | Hentec Industries/RPS AutomationHentec Industries/RPS Automation, a leading manufacturer of selective soldering, lead tinning and solderability test equipment, is pleased to announce that Vicor Power has finalized the purchase of a Pulsar solderability testing system.
Lockheed Martin Successfully Transitions Long Range Discrimination Radar To The Missile Defense Agency
04/23/2024 | Lockheed MartinThe Long Range Discrimination Radar (LRDR) at Clear Space Force Station in Clear, Alaska, completed DD250 final acceptance and was officially handed over to the Missile Defense Agency in preparation for an Operational Capability Baseline (OCB) decision and final transition to the Warfighter. In addition, prior to this transition, the system has started Space Domain Awareness data collects for the United States Space Force.