BEST Installs Cold Component Removal System
October 24, 2022 | BEST, Inc.Estimated reading time: 1 minute
BEST Inc. is pleased to announce the installation of a high-precision milling center the AVX1000M from Air-Vac Engineering.
This milling system allows BEST to remove components using a cold rework process. This process capability replaces the high-temperature desoldering process with a high-precision milling process design for PCBs. This cold removal technique increases PCB rework yields as underfilled components do not have solder pushed around during the removal process thus causing soldering failures. The cold component removal is also appropriate in cases where the components to be removed are very close to heat-sensitive components or where a hot soldering iron may not be easily squeezed into tight spaces.
The AVX1000M is designed for high-end PCB rework. The milling system features precision laser measuring and alignment controls for removing the entire component to within a few thousandths of the PCB surface. The milling center also has vibration control including an integrated vacuum fixture. The machine has a built-in vacuum system to prevent debris from contaminating the PCB during the milling operation.
Dan Patten, BEST general manager stated “With this service capability BEST can now service customers requiring high volume rework of underfilled PCBs. This is going to be beneficial for automotive, consumer and military customers with handheld device using underfill.”
Suggested Items
Taiyo Circuit Automation Installs New DP3500 into Fuba Printed Circuits, Tunisia
04/25/2024 | Taiyo Circuit AutomationTaiyo Circuit Automation is proud to be partnered with Fuba Printed Circuits, Tunisia part of the OneTech Group of companies, a leading printed circuit board manufacturer based out of Bizerte, Tunisia, on their first installation of Taiyo Circuit Automation DP3500 coater.
Vicor Power Orders Hentec Industries/RPS Automation Pulsar Solderability Testing System
04/24/2024 | Hentec Industries/RPS AutomationHentec Industries/RPS Automation, a leading manufacturer of selective soldering, lead tinning and solderability test equipment, is pleased to announce that Vicor Power has finalized the purchase of a Pulsar solderability testing system.
AIM Solder’s Dillon Zhu to Present on Ultraminiature Soldering at SMTA China East
04/22/2024 | AIMAIM Solder, a leading global manufacturer of solder assembly materials for the electronics industry, is pleased to announce that Dillon Zhu will present on the topic: Ultraminiature Soldering: Techniques, Technologies, and Standards at SMTA China East. This event is being held at the Shanghai World Expo Exhibition & Convention Center from April 24-25.
AIM to Highlight NC259FPA Ultrafine No Clean Solder Paste at SMTA Wisconsin Expo & Tech Forum
04/18/2024 | AIMAIM Solder, a leading global manufacturer of solder assembly materials for the electronics industry, is pleased to announce its participation in the upcoming SMTA Wisconsin Expo & Tech Forum taking place on May 7 at the Four Points by Sheraton | Milwaukee Airport, in Milwaukee, Wisconsin.
Hentec/RPS Publishes an Essential Guide to Selective Soldering Processing Tech Paper
04/17/2024 | Hentec Industries/RPS AutomationHentec Industries/RPS Automation, a leading manufacturer of selective soldering, lead tinning and solderability test equipment, announces that it has published a technical paper describing the critical process parameters that need to be optimized to ensure optimal results and guarantee the utmost in end-product quality.