NASA’s InSight Mars Lander Gets a Power Boost
June 4, 2021 | NASAEstimated reading time: 5 minutes
The spacecraft successfully cleared some dust off its solar panels, helping to raise its energy and delay when it will need to switch off its science instruments.
The team behind NASA’s InSight Mars lander has come up with an innovative way to boost the spacecraft’s energy at a time when its power levels have been falling. The lander’s robotic arm trickled sand near one solar panel, helping the wind to carry off some of the panel’s dust. The result was a gain of about 30 watt-hours of energy per sol, or Martian day.
Mars is approaching aphelion, its farthest point from the Sun. That means less sunlight reaches the spacecraft’s dust-covered solar panels, reducing their energy output. The team had planned for this before InSight’s two-year mission extension. They’ve designed the mission to operate without science instruments for the next few months before resuming science operations later this year. During this period, InSight will reserve power for its heaters, computer, and other key components.
The power boost should delay the instruments being switched off by a few weeks, gaining precious time to collect additional science data. The team will try to clear a bit more dust from the same solar panel this Saturday, June 5, 2021.
Dust in the Wind
InSight’s team has been thinking up ways to try to clear dust from its solar panels for almost a year. For example, they tried pulsing the solar panel deployment motors (last used when InSight opened its solar panels after landing) to shake the dust off but didn’t succeed.
More recently, several members of the science team started pursuing the counterintuitive technique of trickling sand near – but not directly on top of – the panels. Matt Golombek, a member of the InSight science team at NASA’s Jet Propulsion Laboratory in Southern California, which manages the mission, noted that it might be possible to strike dust on the panels with sand grains that would “saltate,” or hop off the solar panel surface and skip through the air in the wind. The larger grains might then carry off the smaller dust particles in the wind.
To try the technique, the team used the scoop on InSight’s robotic arm to trickle sand next to InSight’s solar panels on May 22, 2021, the 884th sol of the mission, at around noon Mars time – the windiest time of day. It was easiest for InSight’s arm to be positioned over the lander’s deck, high enough for the winds to blow sand over the panels. Sure enough, with winds blowing northwest at a maximum of 20 feet (6 meters) per second, the trickling of sand coincided with an instantaneous bump in the spacecraft’s overall power.
“We weren’t sure this would work, but we’re delighted that it did,” Golombek said.
While it’s no guarantee that the spacecraft has all the power it needs, the recent cleaning will add some helpful margin to InSight’s power reserves.
Surviving on Mars
InSight’s panels have outlasted the two-year prime mission they were designed for and are now powering the spacecraft through the two-year extension. Relying on solar panels for power enables such missions to be as light as possible for launch and requires fewer moving parts – thus, fewer potential failure points – than other systems. Equipping the spacecraft with brushes or fans to clear off dust would add weight and failure points. (Some members of the public have suggested using the Ingenuity Mars Helicopter’s whirring blades to clear off InSight’s panels, but that’s not an option, either: The operation would be too risky, and the helicopter is roughly 2,145 miles, or 3,452 kilometers, away.)
However, as the Spirit and Opportunity Mars rovers showed, gusts and whirlwinds can clear solar panels over time. In the case of InSight, the spacecraft’s weather sensors have detected many passing whirlwinds, but none have cleared any dust.
By August, as Mars moves in its orbit closer to the Sun, InSight’s solar panels should be able to gather more energy, allowing the team to turn the science instruments back on. Depending on the available power, they might begin by turning some on for short periods at key times during the day, as they’ve been doing to save energy.
Whether the instruments are on or off, InSight operations will pause again around Oct. 7, when Mars and the Earth will be on opposite sides of the Sun. Known as Mars Solar Conjunction, this period happens every two years. Because plasma from the Sun can interrupt radio signals sent to spacecraft at that time, all of NASA’s Mars missions will become more passive, continuing to record data and send updates to engineers on Earth, though no new commands will be sent back to them. The moratorium on Mars commands will last several weeks until late October.
More About the Mission
JPL manages InSight for NASA’s Science Mission Directorate. InSight is part of NASA’s Discovery Program, managed by the agency’s Marshall Space Flight Center in Huntsville, Alabama. Lockheed Martin Space in Denver built the InSight spacecraft, including its cruise stage and lander, and supports spacecraft operations for the mission.
A number of European partners, including France’s Centre National d’Études Spatiales (CNES) and the German Aerospace Center (DLR), are supporting the InSight mission. CNES provided the Seismic Experiment for Interior Structure (SEIS) instrument to NASA, with the principal investigator at IPGP (Institut de Physique du Globe de Paris). Significant contributions for SEIS came from IPGP; the Max Planck Institute for Solar System Research (MPS) in Germany; the Swiss Federal Institute of Technology (ETH Zurich) in Switzerland; Imperial College London and Oxford University in the United Kingdom; and JPL. DLR provided the Heat Flow and Physical Properties Package (HP3) instrument, with significant contributions from the Space Research Center (CBK) of the Polish Academy of Sciences and Astronika in Poland. Spain’s Centro de Astrobiología (CAB) supplied the temperature and wind sensors.
Related Video:
Suggested Items
Infineon Expands Leading Market Position in Automotive Semiconductors
04/11/2024 | InfineonInfineon Technologies AG continued to expand its leading market position in automotive semiconductors in 2023. According to the latest research by TechInsights, the global automotive semiconductor market grew by 16.5 percent in 2023, reaching a new record size of US$69.2 billion.
I-Connect007 Adds to Technical Library With Book on Factory Analytics by Cogiscan
04/03/2024 | I-Connect007I-Connect007 is pleased to announce the launch of The Printed Circuit Assembler’s Guide to… Factory Analytics: Unlocking Efficiency Through Data Insights. Thirty-eighth in a series of educational technical books published by I-Connect007, this book is a guide to understanding how analyzing your factory data is the key to competitive advantage for your factory.
Cogiscan Collaborates with Koh Young to Unveil How Factory Insights Software Transforms Data Into Action at IPC APEX EXPO
03/28/2024 | Koh YoungKoh Young, the industry leader in True3D measurement-based inspection solutions, is excited to announce Factory Insights, the latest offering from Cogiscan, will be demonstrated alongside KSMART in Koh Young booth 2112 during IPC APEX Expo.
It’s Only Common Sense: Get to Know Your Customers
03/18/2024 | Dan Beaulieu -- Column: It's Only Common SenseNo matter what business you are in, understanding your customers is crucial if you want to thrive. You must have a complete understanding of who they are, their business, and what it takes to be successful. In short, you have to see things from their perspective. Too often, we assume we know who our customers are and what they want, but without the proper research and vetting, we can be wrong, which can really send us on the wrong path when it comes to accurately providing them exactly what it is they need from us, our products, and our services.
Arch Systems Showcases Cutting-Edge Manufacturing Solutions at IPC APEX EXPO 2024
03/12/2024 | Arch SystemsArch Systems, a leader in machine data and manufacturing analytics, will exhibit at the 2024 IPC APEX EXPO, taking place from April 9-11 at the Anaheim Convention Center in California.