IPC’s PCB Tech Trends Study Highlights Issues Impacting Fabricators


Reading time ( words)

The recent publication of IPC’s 2018 PCB Technology Trends study highlighted several significant trends that will impact the board fabricator going forward over the next five years.

Some of the most significant technology trends I see are in the materials segment. We all recognize that laminate materials are the substrates on which circuit boards are built. However, these materials perform critical multiple functions in an interconnect device. Important attributes such as signal integrity, impedance, frequency, and ability to withstand high soldering and operating temperatures are just a few.

The 2018 survey results indicated the need for speed and low loss as critical functions of the materials chosen. This is the digital age, and with the Internet of Things, virtual and augmented reality, vehicle-to-vehicle communication, etc., the need for low-loss and ultra-low-loss materials continues to grow as a percentage of circuit boards fabricated. The OEMs’ responses suggested that applications for frequencies greater than 20 GHz will almost double by 2023 over 2018. Indeed, there is a small group of OEMs pushing 77 GHz currently. There is discussion that over the next 5-8 years we will see 100 GHz. The survey results also showed a significant uptick in the use and specification of liquid crystal polymer (LCP), PTFE and ceramic-filled materials in order to support the need for higher operating frequencies.

These materials must not only provide enhanced electrical properties, but must also provide higher reliability against thermal decomposition, operating temperature extremes, and more operating cycles per day. These issues place significant pressure on the material performance. Temperature of decomposition (Td) is assuming more importance going into 2023. As major OEMs continue to push lead-free assembly and require improvements in long-term reliability, thermal decomposition of materials become a significant influence. There is a growing need for Td greater than 340°C.

These trends are significant and will require a change in the way PCB fabricators approach processes used to fabricate these circuit boards. Changes will be required in interlayer processing, lamination equipment and parameters, surface preparation and metalization. These higher performance materials become more difficult to process chemically. Thus, operating windows and the need for improved process controls becomes paramount moving into 2023 and beyond.

Share

Print


Suggested Items

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

04/16/2021 | Nolan Johnson, I-Connect007
I’m sure it’s just me being hyperaware, but I can’t shake it: Mars is where it’s at right now. Is it just me, or do you get the same feeling from the news? There are the Mars rovers—three generations of them still rolling, now—and a drone helicopter winding up for a maiden flight any day now. But that’s not all. There’s SpaceX’s StarShip, rapid-prototyping its way into a manned flight to Mars. And NASA’s whole “return to the Moon” project is simply a shakedown for the U.S. government contractors’ Mars flight hardware, too.

Finding Process Improvement Opportunities in Training

02/25/2021 | Nolan Johnson, PCB007
Nolan Johnson speaks with Leo Lambert of EPTAC about training the next generation out of high school and vocational schools, and how his company continues to improve processes, grow and adapt to changing requirements while fulfilling its mission to deliver technical certification training.

EIPC Technical Snapshot: PCB Surface Finishes

12/28/2020 | Pete Starkey, I-Connect007
For the third in a series of Technical Snapshot webinars, EIPC chose to focus on PCB surface finishes, comparing specific properties, examining corrosion behaviour and discussing selection criteria for low-loss, high frequency applications.



Copyright © 2021 I-Connect007. All rights reserved.