-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueLevel Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
Opportunities and Challenges
In this issue, our expert contributors discuss the many opportunities and challenges in the PCB design community, and what can be done to grow the numbers of PCB designers—and design instructors.
Embedded Design Techniques
Our expert contributors provide the knowledge this month that designers need to be aware of to make intelligent, educated decisions about embedded design. Many design and manufacturing hurdles can trip up designers who are new to this technology.
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
Quiet Power: Measurement-to-Simulation Correlation on Thin Laminate Test Boards
A year ago, I introduced causal and frequency-dependent simulation program with integrated circuit emphasis (SPICE) grid models for simulating power-ground plane impedance. The idea behind the solution was to calculate the actual R, L, G, and C parameters for each of the plane segments separately at every frequency point, run a single-point AC simulation, and then stitch the data together to get the frequency-dependent AC response. Here, using the measured and simulated data on test boards with four different thin laminates and a regular reference laminate, I will demonstrate how that simple model correlates to measured data and simulation results from other tools.
A number of different test boards were fabricated, tested, and simulated. The active area of all boards was 6x6” square, and all boards had the same four-layer construction.
The 4-mil regular FR406 laminate served as a baseline since it is common in low-cost PCBs as a power-ground sandwich. The other four options represent thin laminates in the range of 1 mil down to 0.35 mils in thickness. To check for the effect of copper weight and type, the 1-mil and 0.5-mil laminates had 1-ounce electrodeposited (ED) copper, while the thinnest option used two-ounce copper with ED and rolled-annealed (RA) variants.
To attach probes of measuring instruments and various bypass components to the board, there were 121 via pairs arranged as test points on a 0.5-inch grid. The via pairs are arranged on a 0.5-inch grid centered on the board. The corner and center labels mark the test points where I measured and simulated the planes.
To read this entire column, which appeared in the November 2018 issue of Design007 Magazine, click here.
More Columns from Quiet Power
Quiet Power: The Effect on SI and PI Board PerformanceQuiet Power: 3D Effects in Power Distribution Networks
Quiet Power: Noise Mitigation in Power Planes
Quiet Power: Uncompensated DC Drop in Power Distribution Networks
Quiet Power: Ask the Experts—PDN Filters
Quiet Power: Friends and Enemies in Power Distribution
Quiet Power: Be Aware of Default Values in Circuit Simulators
Quiet Power: Do You Really Need That Ferrite Bead in the PDN?