Real Time with... IPC APEX EXPO: PCB Manufacturing Today


Reading time ( words)

Dick Crowe speaks with Kurt Palmer, president of Burkle North America, about the trends he sees in PCB manufacturing today. From LDI to laser drills, they discuss a wide range of concerns and opportunities.

Watch this interview below or click here to view on our show page. If you didn't make it to IPC APEX EXPO, don't worry. We're bringing you coverage of the week's events, from ribbon cutting to teardown.

Share




Suggested Items

A Focus on Process Control, Part 1

09/27/2022 | I-Connect007 Editorial Team
Michael Carano is a noted subject matter expert with respect to process control, electroplating and metallization technology, surface finishing, and reliability. So, it was only natural that we sat down to talk about mechanizing an existing facility given today’s fickle environment. Will any of the CHIPS funding trickle down to bare board fabrication? What process can be adjusted on the factory floor? The focus needs to be more than just on manufacturing and getting work out the door, he says, but also process control.

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

09/23/2022 | Andy Shaughnessy, Design007 Magazine
It’s officially fall now, and in Atlanta the temperature has plummeted to the mid-80s. We’ve all bumped our air conditioners up to 74 degrees. That means it’s trade show season, and I’ve been busy looking for my suitcase. This week, we have an assortment of news about associations, education, and advocacy, as well as another installment of our Printed Electronics Roundtable. And if you’re looking for a job, you are in luck; our jobConnect007 section is chock-full of open positions at all levels in this industry.

IPC: Companies Are Intentional About Tracking Environmental and Social Risks

09/22/2022 | Suhani Chitalia and Kelly Scanlon, IPC
Leading companies in the electronics manufacturing industry are highly intentional about their environmental, social and governance (ESG) priorities, with climate change and energy use among the most closely scrutinized issues, an IPC analysis shows. As part of IPC’s ESG for Electronics initiative, IPC is interested in developing resources for members on the most common ESG methods and priorities of leading companies across the electronics value chain. In support of this, IPC has preliminarily analyzed the ESG reports of approximately a dozen companies in selected portions of the industry.



Copyright © 2022 I-Connect007. All rights reserved.