Accurate Circuit Engineering Inc. Chooses atg Flying Probe Technology


Reading time ( words)

atg Luther & Maelzer GmbH, confirms the order for high-speed bare board testing technology.

The atg A5EO 8 head, double-sided, high speed, flying probe test system has been ordered and installed at Accurate Circuit Engineering Inc., in Santa Ana, CA.  

James Hofer, general manager stated:” ACE needed to upgrade our testing capabilities to stay on the leading edge of the market and the atg unit exceeded our expectations in all of our process capability models”.

atg’s A5 testers utilize 8 test heads (four per side), multiple optical recognition systems, and a wide variety of advanced, high-speed electrical test measurement techniques to electrically test all types of PCBs for continuity and isolation. Special options, such as, 4-wire Kelvin test, Hi-pot test, Latent defect test, and others can be provided.

Accurate Circuit Engineering Inc., is a leading provider of high speed HF and Microwave PCB products. Credentials include ISO 9001, ISO 14001, AS9100, ITAR, UL as well as MIL-PRF 31032 and MIL-PRF 55110 certifications.

About atg Luther & Maelzer GmbH

With more than 190 employees worldwide, atg Luther & Maelzer is the leading supplier of electrical testing solutions for the Printed Circuit Board industry. Our atg flying probe tester products are renowned for automation, speed, accuracy, versatility, and ease of use, while the Luther & Maelzer universal grid tester product range is known worldwide for high throughput, repeatability and automation.

Share

Print


Suggested Items

Happy Holden Book Excerpt: CIM & Automation Strategy

05/22/2020 | Happy Holden, I-Connect007
The following is an excerpt from Chapter 1 of Happy Holden’s I-Connect007 eBook Automation and Advanced Procedures in PCB Fabrication. In this book, Happy explains fabrication automation with illustrative examples and anecdotes from his decades as a mechanization leader.

The Smart Factory: All the Bits and Bobs

03/26/2020 | Happy Holden, I-Connect007
“Smart factory” is another phrase that describes Industry 4.0 programs. These programs seem to have replaced CIM and CAM, but it did not make them obsolete. While these topics are getting a lot of press, there is nothing new about them. We have been on a journey to automate manufacturing since the mid-‘70s. What has evolved are faster and cheaper computers, and more complex and integrated networking.

Alex Stepinski: GreenSource Fabrication Update

01/22/2020 | Barry Matties, I-Connect007
Alex Stepinski gives an update on GreenSource, their acquisition of AWP, and their move to full production after some delays. Barry Matties and Alex also discuss automation and the difficulties in hiring in the U.S. and announces the decision to go to market with their recycling equipment in 2020.



Copyright © 2021 I-Connect007. All rights reserved.