RTW SMTAI: AIM's Dr. Mehran Maalekian Speaks on New Alloys for Harsh Environments


Reading time ( words)

During the recent SMTA International 2017 trade exhibition in Rosemont, Illinois, Dr. Mehran Maalekian, R&D Manager at AIM Solder, speaks with I-Connect007 Managing Editor Andy Shaughnessy about new alloys that are targeted for high-temperature and demanding applications, particularly in harsh environments, where standard lead-free alloy such as SAC will not perform as well.

Watch the Interview Here

Share

Print


Suggested Items

Super Dry: Increasing Component Storage Needs

03/03/2021 | Nolan Johnson, I-Connect007
Nolan Johnson speaks with Super Dry’s Richard Heimsch about how the need for dry storage solutions has increased throughout the pandemic, including further demands for traceability and automation capabilities.

SMTA Europe Webinar: What Is a Good Solder Joint, and How Can Solder Joints Be Tested?

11/18/2020 | Pete Starkey, I-Connect007
What is a good solder joint? And how can they be tested not only for purposes of process characterisation, optimisation, monitoring, and control but also for ensuring their long-term reliability? Pete Starkey details a webinar organised by the Europe Chapter of SMTA that was presented by Bob Willis, an expert in soldering, assembly technologies, and failure analysis.

Reducing Flux Splatter in Sensors and Camera Modules

10/30/2020 | Jasbir Bath, Shantanu Joshi, and Noriyoshi Uchida, Koki Solder America And Koki Company Limited
With the increased use of electronics in new technology areas, flux formulations are being developed to address the new and existing requirements. For sensors and camera modules used for Advanced Driver Assistance System (ADAS) and internet of things (IoT) applications, there is a demand for no-clean flux formulations in lead-free solder paste, which can reduce flux splattering during reflow.



Copyright © 2021 I-Connect007. All rights reserved.