Airbus VSR700 Helicopter Prototype Performs First Autonomous Free Flight
August 10, 2020 | AirbusEstimated reading time: 1 minute
The prototype of Airbus Helicopters’ VSR700 unmanned aerial system (UAS) has performed its first free flight. The VSR700 performed a 10-minute flight at a drone test centre near Aix-en-Provence in the south of France.
This is a significant step in the programme following the first flight in November 2019 when the prototype was tethered to comply with regulatory requirements. To enable this free flight, Airbus Helicopters implemented geofencing, a virtual perimeter, which enabled and justified a flight clearance from airworthiness authorities for free flight. The flight test programme will now evolve to progressively open the flight envelope.
“The free flight achieved by the VSR700 is a major step leading up to the sea trials that will be performed at the end of 2021 as part of the de-risking studies for the French Navy’s future drone,” said Bruno Even, Airbus Helicopters CEO. “Thanks to the French PlanAero, the programme will make full use of two demonstrators and an optionally piloted vehicle to develop and mature the technical and operational aspects for successful UAS operations in a naval environment.”
The VSR700, derived from Hélicoptères Guimbal’s Cabri G2, is an unmanned aerial system in the 500-1000 kg maximum take-off weight range. It offers the best balance of payload capability, endurance and operational cost. It is capable of carrying multiple full-size naval sensors for extended periods and can operate from existing ships, alongside a helicopter, with a low logistical footprint.
This VSR700 prototype has evolved over the last nine months since its maiden flight. The programme implemented the geofencing function, as well as a Flight Termination System allowing the mission to be ended if necessary. Modifications have equally been performed to the air vehicle, alongside autopilot software evolutions and updates, as well as structural modifications and reinforcements.
Suggested Items
I-Connect007 Editor’s Choice: Five Must-Reads for the Week
05/03/2024 | Nolan Johnson, I-Connect007This week’s most important news is strategic—and telling. When one puts together the IPC industry reports, we simply have to include the recent conversation with Shawn DuBravac and Tom Kastner. On the design side, check out the latest “On The Line With…” podcast featuring Brad Griffin from Cadence Design Systems, discussing SI and PI in the realm of intelligent system design.
Industrial PC Market Size to Record $1.75 Billion Growth from 2023-2027
05/03/2024 | PRNewswireThe global industrial pc market size is estimated to grow by USD 1.75 billion from 2023 to 2027, according to Technavio. This growth is expected to occur at a Compound Annual Growth Rate (CAGR) of almost 6.29% during the forecast period.
Real Time with… IPC APEX EXPO 2024: Sigma Engineering's Recycling and Regeneration Systems for PCB Etching
05/02/2024 | Real Time with...IPC APEX EXPOEvan Howard of Schmoll America interviews Kristoffer Bjorklund, Sigma Engineering's supply chain manager. We learn about Sigma's recycling and regeneration systems for PCB industry etching and the benefits and challenges of implementing these systems in existing factories.
Boeing T-7A Red Hawk Triples Progress
05/01/2024 | BoeingThe Boeing T-7A Red Hawk achieved three recent milestones, propelling the advanced pilot trainer for the U.S. Air Force forward.
Merlin Flex invests in New Schmoll Direct Imaging System
04/30/2024 | Merlin Flex LtdMerlin Flex has fully installed and commissioned its 2nd Schmoll MDI Direct Imaging system. This new machine includes a twin bed, 4 head system which enhances Merlin Flex’s direct imaging capability for its 1.4M long flexible circuits.